Manual Pages  — DTSEC

dtsec – Freescale Datapath Acceleration Architecture-based Three-Speed Ethernet Controller device driver

SYNOPSIS DESCRIPTION HARDWARE SEE ALSO HISTORY AUTHORS

To compile this driver into the kernel, place the following lines in your kernel configuration file: include dpaa/config.dpaa" device dpaa device miibus

The dtsec driver provides support for the DPAA-based gigabit Ethernet controller integrated in some of the Freescale system-on-chip devices.

The dtsec driver supports the following media types:

autoselect	Enable autoselection of the media type and options
10baseT/UTP	Set 10Mbps operation
100baseTX	Set 100Mbps operation
1000baseT	Set 1000baseT operation

The dtsec driver supports the following media options:

full-duplex	Set full duplex operation

The dtsec driver supports two operating modes:

Regular	Normal mode, utilizing the full datapath acceleration, Buffer Manager, and Queue Manager.
Independent	Runs disconnected from the Buffer Manager and Queue Manager.

Gigabit Ethernet controllers built into the following Freescale system-on-chip devices are known to work with the dtsec driver:

• P2041, P3041
• P5010, P5020

Additionally, the following devices are expected to work, but are untested:

• P4080, P4040
• P5040

The dtsec device driver first appeared in FreeBSD 11.0 .

The base version of dtsec device driver was written by Semihalf. This manual page was written by Justin Hibbits.