Manual Pages  — MEM

struct mem_extract {
        uint64_t        me_vaddr;       /* input */
        uint64_t        me_paddr;       /* output */
        int             me_domain;      /* output */
        int             me_state;       /* output */
};

The ioctl returns an error if the address is not valid. The information returned by MEM_EXTRACT_PADDR may be out of date by the time that the ioctl call returns. Specifically, concurrent system calls, page faults, or system page reclamation activity may have unmapped the virtual page or replaced the backing physical page before the ioctl call returns. Wired pages, e.g., those locked by mlock(2), will not be reclaimed by the system.

The me_state field provides information about the state of the virtual page:

ME_STATE_INVALID
	The virtual address is invalid.
ME_STATE_VALID
	The virtual address is valid but is not mapped at the time of the ioctl call.
ME_STATE_MAPPED
	The virtual address corresponds to a physical page mapping, and the me_paddr and me_domain fields are valid. Several architectures allow attributes to be associated with ranges of physical memory. These attributes can be manipulated via ioctl() calls performed on /dev/mem. Declarations and data types are to be found in <sys/memrange.h>. The specific attributes, and number of programmable ranges may vary between architectures. The full set of supported attributes is:
MDF_UNCACHEABLE
	The region is not cached.
MDF_WRITECOMBINE
	Writes to the region may be combined or performed out of order.
MDF_WRITETHROUGH
	Writes to the region are committed synchronously.
MDF_WRITEBACK
	Writes to the region are committed asynchronously.
MDF_WRITEPROTECT
	The region cannot be written to.

Memory ranges are described by

struct mem_range_desc {
        uint64_t        mr_base;        /* physical base address */
        uint64_t        mr_len;         /* physical length of region */
        int             mr_flags;       /* attributes of region */
        char            mr_owner[8];
};

In addition to the region attributes listed above, the following flags may also be set in the mr_flags field:

MDF_FIXBASE
	The region's base address cannot be changed.
MDF_FIXLEN
	The region's length cannot be changed.
MDF_FIRMWARE
	The region is believed to have been established by the system firmware.
MDF_ACTIVE
	The region is currently active.
MDF_BOGUS
	We believe the region to be invalid or otherwise erroneous.
MDF_FIXACTIVE
	The region cannot be disabled.
MDF_BUSY
	The region is currently owned by another process and may not be altered.

Operations are performed using

struct mem_range_op {
        struct mem_range_desc   *mo_desc;
        int                     mo_arg[2];
};

The MEMRANGE_GET ioctl is used to retrieve current memory range attributes. If mo_arg[0] is set to 0, it will be updated with the total number of memory range descriptors. If greater than 0, the array at mo_desc will be filled with a corresponding number of descriptor structures, or the maximum, whichever is less.

The MEMRANGE_SET ioctl is used to add, alter and remove memory range attributes. A range with the MDF_FIXACTIVE flag may not be removed; a range with the MDF_BUSY flag may not be removed or updated.

mo_arg[0] should be set to MEMRANGE_SET_UPDATE to update an existing or establish a new range, or to MEMRANGE_SET_REMOVE to remove a range.

This device is required for all users of kvm(3) to operate.