| Main index | Section 4 | Options |
The XHCI controller supports USB connection speeds from 5.0Gbps and above when using USB 3.x compliant devices.
| hw.usb.xhci.debug | |
| Set debug output level, where 0 is debugging disabled and larger values increase debug message verbosity. The default value is 0. | |
| hw.usb.xhci.dcepquirk | |
| Set to enable quirk for deconfiguration of endpoints. The default value is 0. | |
| hw.usb.xhci.ctlquirk | |
| Set to submit full USB control request as one job, up to 64kBytes. Else the USB control request will be split into multiple smaller requests. The default value is 1. | |
| hw.usb.xhci.streams | |
| Set to enable USB streams support. The default value is 0. | |
| hw.usb.xhci.route | |
| Set bitmap for switching EHCI ports to the XHCI controller. The default value is 0. | |
| hw.usb.xhci.polling | |
| Set to use a timer to poll the interrupt handler. The default value is 0. | |
| hw.usb.xhci.dma32 | |
| Set to only use 32-bit DMA for the XHCI controller. The default value is 0. | |
| hw.usb.xhci.ctlstep | |
| Set to enable control endpoint status state stepping. The default value is 0. | |
| XHCI (4) | October 21, 2022 |
| Main index | Section 4 | Options |
Please direct any comments about this manual page service to Ben Bullock. Privacy policy.
| “ | Ken Thompson has an automobile which he helped design. Unlike most automobiles, it has neither speedometer, nor gas gauge, nor any of the other numerous idiot lights which plague the modern driver. Rather, if the driver makes a mistake, a giant “?” lights up in the center of the dashboard. “The experienced driver,” says Thompson, “will usually know what's wrong.” | ” |