Manual Pages — ACPI_RAPIDSTART

NAME

acpi_rapidstart – Intel rapid start technology ACPI driver

SYNOPSIS
DESCRIPTION
SYSCTLS
SEE ALSO
HISTORY
AUTHORS

SYNOPSIS

To compile this driver into the kernel, place the following line in your kernel configuration file: device acpi_rapidstart

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

acpi_rapidstart_load="YES"

DESCRIPTION

The acpi_rapidstart driver provides support for Intel Rapid Start technology ACPI device interface. Note that this is only for the ACPI device interface. This has _CID PNP0C02 so it should be loaded at boot time to avoid attaching to the acpi_sysresource driver.

SYSCTLS

The following sysctl(8) nodes are currently implemented:

dev.acpi_rapidstart.0.ffs
	Rapid start flag. It is a bitwise OR of the following:

`1`	Enter Fast Flash Standby in RTC wake.
`2`	Enter Fast Flash Standby in Critical Battery Wake enable

dev.acpi_rapidstart.0.ftv
	Fast Flash Standby timer value in minutes.

HISTORY

The acpi_rapidstart driver first appeared in FreeBSD 10.0 .

AUTHORS

The acpi_rapidstart driver was written by Takanori Watanabe <Mt takawata@FreeBSD.org>.

ACPI_RAPIDSTART (4)

May 8, 2013

Copyright: The copyright notice of this manual page is here (plain text).

Please direct any comments about this manual page service to Ben Bullock. Privacy policy.

“

I have a natural revulsion to any operating system that shows so little planning as to have to named all of its commands after digestive noises (awk, grep, fsck, nroff).

”