tail head cat sleep
QR code linking to this page

Manual Pages  — BHND

NAME

bhnd – Broadcom Home Networking Division interconnect bus

CONTENTS

SYNOPSIS

To compile this driver into the kernel, add the following lines to the kernel configuration file: device bhnd

To load the driver as a module at boot, add this line to loader.conf(5):

bhnd_load="YES"

DESCRIPTION

The bhnd driver provides a unified kernel bus interface to the on-chip interconnects used in Broadcom Home Networking Division (HND) devices.

The Broadcom HND device family consists of SoCs (System On a Chip) and host-connected chipsets based on a common library of Broadcom IP cores connected via an internal hardware bus architecture. Drivers for these cores are implemented against the unified bhnd interface.

The Sonic Inc. Silicon Backplane used in earlier HND devices is supported by the siba(4) BHND driver.

The ARM AMBA-based interconnect used in later HND devices is supported by the bcma(4) BHND driver.

SEE ALSO

bcma(4), bhndb(4), intro(4), siba(4)

HISTORY

The bhnd device driver first appeared in FreeBSD 11.0 .

AUTHORS

The bhnd driver was written by Landon Fuller <Mt landonf@FreeBSD.org>.

BHND (4) June 3, 2016

tail head cat sleep
QR code linking to this page


Please direct any comments about this manual page service to Ben Bullock. Privacy policy.