tail head cat sleep
QR code linking to this page
Main index Section 4
Go to:
Options

Manual Pages  — ENIC

NAME

enic – VIC Ethernet NIC driver

CONTENTS

SYNOPSIS

To compile this driver into the kernel, place the following lines in your kernel configuration file: device iflib device enic

To load the driver as a module at run-time, run the following command as root: 

kldload if_enic

To load the driver as a module at boot time, place the following lines in loader.conf(5): 

if_enic_load="YES"

DESCRIPTION

The enic driver provides support for Cisco Virtual Interface Card. Support is limited to basic network connectivity. Media is controlled by the NIC itself since there can be multiple virtual PCI NIC devices exposed to the PCI bus.

HARDWARE

The enic driver should supports all known Cisco VIC cards.

CONFIGURATION

The enic network interface is configured using ifconfig(8) and the sysctl(8) tree at dev.enic.<N>. All configurable entries are also tunables, and can be put directly into the loader.conf(5) for persistent configuration.

SEE ALSO

ifconfig(8)

HISTORY

The enic device driver first appeared in FreeBSD 14.0 .

AUTHORS

The enic driver was written by Cisco UCS team based of the DPDK driver.
ENIC (4) September 7, 2022
tail head cat sleep
QR code linking to this page
Main index Section 4
Go to:
Options

Please direct any comments about this manual page service to Ben Bullock. Privacy policy.

“ Some people, when confronted with a problem, think “I know, I'll use regular expressions.” Now they have two problems. ”
— Jamie Zawinski