Manual Pages — BFE

NAME

bfe – Broadcom BCM4401 Ethernet Device Driver

SYNOPSIS
DESCRIPTION
DIAGNOSTICS
SEE ALSO
HISTORY
AUTHORS

SYNOPSIS

To compile this driver into the kernel, place the following lines in your kernel configuration file: device miibus device bfe

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

if_bfe_load="YES"

DESCRIPTION

The bfe driver provides support for Broadcom BCM4401 based Fast Ethernet adapters.

The bfe driver supports the following media types:

autoselect Enable autoselection of the media type and options.

10baseT/UTP

Set 10Mbps operation.

100baseTX Set 100Mbps (Fast Ethernet) operation.

The bfe driver supports the following media options:

full-duplex

Set full duplex operation.

For further information on configuring this device, see ifconfig(8).

DIAGNOSTICS

bfe%d: couldn't map memory	A fatal initialization error has occurred.
bfe%d: couldn't map interrupt	A fatal initialization error has occurred.
bfe%d: failed to allocate DMA resources	There are not enough mbufs available for allocation.
bfe%d: watchdog timeout -- resetting	The device has stopped responding to the network, or there is a problem with the network connection (cable).

HISTORY

The bfe device driver first appeared in FreeBSD 5.1 .

AUTHORS

The bfe device driver was written by Stuart Walsh and Duncan Barclay. This manual page was written by Stuart Walsh.

BFE (4)

July 16, 2005

Copyright: The copyright notice of this manual page is here (plain text).

Please direct any comments about this manual page service to Ben Bullock. Privacy policy.

autoselect	Enable autoselection of the media type and options.
10baseT/UTP
	Set 10Mbps operation.
100baseTX	Set 100Mbps (Fast Ethernet) operation.