Manual Pages — CUE

NAME

cue – CATC USB-EL1210A USB Ethernet driver

SYNOPSIS
DESCRIPTION
HARDWARE
DIAGNOSTICS
SEE ALSO
HISTORY
AUTHORS

SYNOPSIS

To compile this driver into the kernel, place the following lines in your kernel configuration file: device uhci device ohci device usb device miibus device uether device cue

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

if_cue_load="YES"

DESCRIPTION

The cue driver provides support for USB Ethernet adapters based on the Computer Access Technology Corporation's USB-EL1210A chipset.

The USB-EL1210A supports a 512-bit multicast hash filter, single perfect filter entry for the station address and promiscuous mode. Packets are received and transmitted over separate USB bulk transfer endpoints.

The CATC chipset supports only 10Mbps half-duplex mode, hence there are no ifmedia(4) modes to select.

For more information on configuring this device, see ifconfig(8).

HARDWARE

The cue driver supports CATC USB-EL1210A based USB Ethernet adapters including:

Belkin F5U011/F5U111
CATC Netmate
CATC Netmate II
SmartBridges SmartLink

DIAGNOSTICS

cue%d: watchdog timeout	A packet was queued for transmission and a transmit command was issued, however the device failed to acknowledge the transmission before a timeout expired.
cue%d: no memory for rx list	The driver failed to allocate an mbuf for the receiver ring.

HISTORY

The cue device driver first appeared in FreeBSD 4.0 .

AUTHORS

The cue driver was written by Bill Paul <Mt wpaul@ee.columbia.edu>.

CUE (4)

November 24, 2015

Copyright: The copyright notice of this manual page is here (plain text).

Please direct any comments about this manual page service to Ben Bullock. Privacy policy.

“	Using Unix is the computing equivalent of listening only to music by David Cassidy	”
— Rob Pike