tail head cat sleep
QR code linking to this page
Main index Section 4
Go to:
Options

Manual Pages  — KUE

NAME

kue – Kawasaki LSI KL5KUSB101B USB Ethernet driver

CONTENTS

SYNOPSIS

To compile this driver into the kernel, place the following lines in your kernel configuration file: device uhci device ohci device usb device miibus device uether device kue

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5): 

if_kue_load="YES"

DESCRIPTION

The kue driver provides support for USB Ethernet adapters based on the Kawasaki LSI KL5KLUSB101B chipset.

The KL5KLUSB101B supports a 128-entry multicast filter, single perfect filter entry for the station address and promiscuous mode. Packets are received and transmitted over separate USB bulk transfer endpoints.

The Kawasaki chipset supports only 10Mbps half-duplex mode, hence there are no ifmedia() modes to select.

For more information on configuring this device, see ifconfig(8).

HARDWARE

The kue driver supports Kawasaki LSI KL5KLUSB101B based USB Ethernet adapters including:

DIAGNOSTICS

kue%d: watchdog timeout A packet was queued for transmission and a transmit command was issued, however the device failed to acknowledge the transmission before a timeout expired.
kue%d: no memory for rx list The driver failed to allocate an mbuf for the receiver ring.

SEE ALSO

arp(4), netintro(4), ng_ether(4), ifconfig(8)

HISTORY

The kue device driver first appeared in FreeBSD 4.0 .

AUTHORS

The kue driver was written by Bill Paul <Mt wpaul@ee.columbia.edu>.

BUGS

The kue driver does not accumulate Ethernet collisions statistics because the Kawasaki firmware does not appear to maintain any internal statistics.
KUE (4) July 24, 2019
tail head cat sleep
QR code linking to this page
Main index Section 4
Go to:
Options

Please direct any comments about this manual page service to Ben Bullock. Privacy policy.

“ A child of 5 could understand this! Fetch me a child of 5. ”