mfi_linux(4) manual page

To compile this driver into the kernel, place the following lines in your kernel configuration file: device pci device mfi

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

mfi_load="YES"

This driver is for LSI's next generation PCI Express SAS RAID controllers. Access to RAID arrays (logical disks) from this driver is provided via /dev/mfid? device nodes. A simple management interface is also provided on a per-controller basis via the /dev/mfi? device node.

The mfi name is derived from the phrase "MegaRAID Firmware Interface", which is substantially different than the old "MegaRAID" interface and thus requires a new driver. Older SCSI and SATA MegaRAID cards are supported by amr(4) and will not work with this driver.

Two sysctls are provided to tune the mfi driver's behavior when a request is made to remove a mounted volume. By default the driver will disallow any requests to remove a mounted volume. If the sysctl dev.mfi.%d.delete_busy_volumes is set to 1, then the driver will allow mounted volumes to be removed.

A tunable is provided to adjust the mfi driver's behaviour when attaching to a card. By default the driver will attach to all known cards with high probe priority. If the tunable hw.mfi.mrsas_enable is set to 1, then the driver will reduce its probe priority to allow mrsas to attach to the card instead of mfi.

mfi does not provide ATA TRIM support. Refer to mrsas if TRIM support is required.

amr(4), pci(4), mfiutil(8)

Manual Pages — MFI

NAME

CONTENTS

SYNOPSIS

DESCRIPTION

HARDWARE

FILES

DIAGNOSTICS

SEE ALSO

HISTORY

AUTHORS

BUGS

`/dev/mfid?`
	array/logical disk interface
`/dev/mfi?`	management interface