QR code linking to this page

Manual Pages — NCV

NAME

ncv – NCR 53C500 based SCSI host adapter driver

CONTENTS

SYNOPSIS
DESCRIPTION
HARDWARE
DIAGNOSTICS
SEE ALSO
HISTORY
AUTHORS

SYNOPSIS

To compile this driver into the kernel, place the following lines in your kernel configuration file: device scbus device ncv

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

ncv_load="YES"

DESCRIPTION

The ncv driver provides access to the SCSI bus connected to an NCR 53C500 based PC-Card SCSI host adapter or an Adaptec AHA-2920 on the PCI bus.

HARDWARE

The following devices are currently supported by the ncv driver:

I-O DATA PCSC-DV
KME KXLC002 (TAXAN ICD-400PN, etc.), KXLC004, and UJDCD450
Macnica Miracle SCSI-II mPS110
Media Intelligent MSC-110, MSC-200
New Media Corporation BASICS SCSI
Qlogic Fast SCSI
RATOC REX-9530, REX-5572 (SCSI only)

DIAGNOSTICS

The following error messages are sometimes returned:

SCSI BUS RESET failed	Usually returned when a failure occurs during the bus reset.
CMD_NOP failed	No operation or the operation has failed.
CMD_NOP\|CMD_DMA	A failure occurred during the DMA read/write operations.

The ncv driver should return [ENODEV] when any of the previously noted failures occur.

SEE ALSO

cardbus(4), cd(4), da(4), pccard(4), sa(4), scsi(4)

HISTORY

The ncv device driver has been developed for NetBSD and ported to FreeBSD . The ncv driver first appeared in FreeBSD 2.2 with PAO and merged in FreeBSD 4.2 .

AUTHORS

The ncv driver was written by Naofumi Honda. This manual page was written by Tom Rhodes <Mt trhodes@FreeBSD.org> and Noriaki Mitsunaga <Mt non@FreeBSD.org>.

August 10, 2004

QR code linking to this page

Copyright: The copyright notice of this manual page is here (plain text).

Please direct any comments about this manual page service to Ben Bullock. Privacy policy.

“

How do you pronounce UNIX ? You Nix !

”