tail head cat sleep
QR code linking to this page
Main index Section 4
Go to:
Options

Manual Pages  — QLNXE

NAME

qlnxe – Cavium 25/40/100 Gigabit Ethernet & CNA Adapter Driver

CONTENTS

SYNOPSIS

To compile this driver into the kernel, place the following lines in your kernel configuration file: device qlnxe

To load the driver as a module at boot time, place the following line in loader.conf(5): 

if_qlnxe_load="YES"

DESCRIPTION

The qlnxe driver supports IPv4 checksum offload, TCP and UDP checksum offload for both IPv4 and IPv6, Large Segment Offload for both IPv4 and IPv6, Jumbo frames, VLAN Tag, Receive Side scaling, HW and Soft LRO. For further hardware information, see http://www.qlogic.com/.

HARDWARE

The qlnxe driver supports 25/40/100 Gigabit Ethernet & CNA Adapter based on the following chipsets:

SUPPORT

For support questions please contact your Cavium approved reseller or Cavium Technical Support at http://support.qlogic.com, or by E-mail at <Mt support@qlogic.com>.

SEE ALSO

altq(4), arp(4), netintro(4), ng_ether(4), ifconfig(8)

HISTORY

The qlnxe device driver first appeared in FreeBSD 11.1 .

AUTHORS

The qlnxe driver was written by David C Somayajulu at Cavium Inc.
QLNXE (4) May 9, 2017
tail head cat sleep
QR code linking to this page
Main index Section 4
Go to:
Options

Please direct any comments about this manual page service to Ben Bullock. Privacy policy.