tail head cat sleep
QR code linking to this page
Main index Section 4
Go to:
Options

Manual Pages  — QLXGB

NAME

qlxgb – QLogic 10 Gigabit Ethernet & CNA Adapter Driver

CONTENTS

SYNOPSIS

To compile this driver into the kernel, place the following lines in your kernel configuration file: device qlxgb

To load the driver as a module at boot time, place the following line in loader.conf(5): 

if_qlxgb_load="YES"

DESCRIPTION

The qlxgb driver supports IPv4 checksum offload, TCP and UDP checksum offload for both IPv4 and IPv6, Large Segment Offload for both IPv4 and IPv6, Jumbo frames, VLAN Tag, and Receive Side scaling. For further hardware information, see http://www.qlogic.com/.

HARDWARE

The qlxgb driver supports 10 Gigabit Ethernet & CNA Adapter based on the following chipsets:

SUPPORT

For support questions please contact your QLogic approved reseller or QLogic Technical Support at http://support.qlogic.com, or by E-mail at <Mt support@qlogic.com>.

SEE ALSO

altq(4), arp(4), netintro(4), ng_ether(4), ifconfig(8)

HISTORY

The qlxgb device driver first appeared in FreeBSD 10.0 .

AUTHORS

The qlxgb driver was written by David C Somayajulu at QLogic Corporation.
QLXGB (4) November 3, 2011
tail head cat sleep
QR code linking to this page
Main index Section 4
Go to:
Options

Please direct any comments about this manual page service to Ben Bullock. Privacy policy.

“ If you sat a monkey down in front of a keyboard, the first thing typed would be a unix command. ”
— Bill Lye