tail head cat sleep
QR code linking to this page
Main index Section 4
Go to:
Options

Manual Pages  — HPTRR

NAME

hptrr – HighPoint RocketRAID device driver

CONTENTS

SYNOPSIS

To compile this driver into the kernel, place the following line in your kernel configuration file: device hptrr device scbus device da

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5): 

hptrr_load="YES"

The following tunables are settable from the loader:
hw.hptrr.attach_generic set to 1 to permit driver attach to chips with generic Marvell (non-HighPoint) PCI identification. These chips are also supported by ata(4) and mvs(4). Some vendors are using same chips, but without providing RAID BIOS.

DESCRIPTION

The hptrr driver provides support for HighPoint's RocketRAID based RAID controllers.

These devices support SATA/ATA disk drives and provide RAID0 (striping), RAID1 (mirroring), and RAID5 functionality.

HARDWARE

The hptrr driver supports the following RAID controllers:

NOTES

The hptrr driver only works on the i386 and amd64 platforms as it requires a binary blob object from the manufacturer which they only supply for these platforms. The hptrr driver does not work on i386 with pae(4) enabled.

This driver does not support the RR182x series controller. See the hptmv(4) manual page for details on support.

This driver supersedes the older rr232x driver.

SEE ALSO

ata(4), cam(4), hptmv(4), mvs(4), loader(8)

HISTORY

The hptrr device driver first appeared in FreeBSD 6.3 .

AUTHORS

The hptrr device driver was written by HighPoint Technologies, Inc., and ported to FreeBSD by Scott Long. This manual page was written by David E. O'Brien.

BUGS

The hptrr driver does not support manipulating the RAID from the OS, RAIDs need to be set up from the on-board BIOS.
HPTRR (4) June 6, 2012
tail head cat sleep
QR code linking to this page
Main index Section 4
Go to:
Options

Please direct any comments about this manual page service to Ben Bullock. Privacy policy.

“ This philosophy, in the hands of amateurs, leads to inexplicably mind-numbing botches like the existence of two programs, “head” and “tail,” which print the first part or the last part of a file, depending. Even though their operations are duals of one another, “head” and “tail” are different programs, written by different authors, and take different options! ”
— The Unix Haters' handbook