tail head cat sleep
QR code linking to this page
Main index Section 4
Go to:
Options

Manual Pages  — SND_VIA8233

NAME

snd_via8233 – VIA Technologies VT8233 bridge device driver

CONTENTS

SYNOPSIS

To compile this driver into the kernel, place the following lines in your kernel configuration file: device sound device snd_via8233

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5): 

snd_via8233_load="YES"

DESCRIPTION

The snd_via8233 bridge driver allows the generic audio driver, sound(4), to attach to the VIA VT8233 audio devices. These audio chipsets are integrated in the southbridge on many VIA based motherboards.

Runtime Configuration

The following sysctl(8) variables are available in addition to those available to all sound(4) devices:
dev.pcm.%d.polling
  Experimental polling mode, where the driver operates by querying the device state on each tick using callout(9). Polling is disabled by default. Do not enable it unless you are facing weird interrupt problems or if the device cannot generate interrupts at all.

HARDWARE

The snd_via8233 driver supports the following audio chipsets:

SEE ALSO

sound(4)

HISTORY

The snd_via8233 device driver first appeared in FreeBSD 4.7 .

AUTHORS

This manual page was written by Joel Dahl <Mt joel@FreeBSD.org>.

BUGS

The snd_via8233 driver does not support S/PDIF. There is partial support in the code, so implementing it should be fairly easy if the right hardware is available.
SND_VIA8233 (4) November 29, 2006
tail head cat sleep
QR code linking to this page
Main index Section 4
Go to:
Options

Please direct any comments about this manual page service to Ben Bullock. Privacy policy.

“ The most important thing in the programming language is the name. A language will not succeed without a good name. I have recently invented a very good name and now I am looking for a suitable language. ”
— Donald Knuth