if_sge(4) manual page

To compile this driver into the kernel, place the following lines in your kernel configuration file: device miibus device sge

Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

if_sge_load="YES"

The sge device driver provides support for SiS190 Fast Ethernet controllers and SiS191 Fast/Gigabit Ethernet controllers.

All LOMs supported by the sge driver have TCP/UDP/IP checksum offload for transmit and receive, TCP segmentation offload (TSO), hardware VLAN tag stripping/insertion features. Due to lack of documentation Wake On Lan (WOL), Jumbo frame and an interrupt moderation mechanism are not supported yet.

The sge driver supports the following media types:

autoselect Enable autoselection of the media type and options. The user can manually override the autoselected mode by adding media options to rc.conf(5).

10baseT/UTP

Set 10Mbps operation.

100baseTX Set 100Mbps (Fast Ethernet) operation.

1000baseTX Set 1000baseTX operation over twisted pair.

The sge driver supports the following media options:

full-duplex

Force full duplex operation.

half-duplex

Force half duplex operation.

For more information on configuring this device, see ifconfig(8).

altq(4), arp(4), miibus(4), netintro(4), ng_ether(4), rgephy(4), vlan(4), ifconfig(8)

“	The Unix phenomenon is scary. It doesn't go away.	”
— Steve Ballmer

Manual Pages — SGE

NAME

CONTENTS

SYNOPSIS

DESCRIPTION

HARDWARE

SEE ALSO

HISTORY

autoselect	Enable autoselection of the media type and options. The user can manually override the autoselected mode by adding media options to rc.conf(5).
10baseT/UTP
	Set 10Mbps operation.
100baseTX	Set 100Mbps (Fast Ethernet) operation.
1000baseTX	Set 1000baseTX operation over twisted pair.

full-duplex
	Force full duplex operation.
half-duplex
	Force half duplex operation.